APC AP9268 User Manual
Page 23
APC KVM Switch Installer/User Guide
18
Editing Channel Names and Addresses
1. Highlight the channel you wish to change in the main OSD Window.
2. Press the Control key twice to access the Command Menu or press the F2 key
once. (If you press F2, skip Step 3.)
3. Select ‘Edit Channel’ from the Command Menu.
4. Enter the new channel name, address, ID Dwell time and Scan Dwell time.
Press Enter to accept.
5. After selecting “ID Setup”, use the arrow keys, position the ID window
to where you would like it to appear when this channel is selected.
Then press Enter. (For further information see ‘The ID Window’ later
in this chapter.)
6. Select “Save Changes” and press Enter to accept.
Press Esc at any point to exit this operation without saving the changes.
Deleting an Existing Channel
1. Highlight the channel you wish to delete in the main OSD Window.
2. Press the Control key twice to access the Command Menu or simply press
the DELETE key. (If you press DELETE, skip Step 3.)
3. Choose the ‘Delete Channel’ option.
4. Type Y or N at the prompt to confi rm the deletion and press Enter.