AirSep MN170-1 D User Manual
Page 22
MN170-1 rev D
18
The optional AirBelt will completely recharge from its fully depleted state in approximately 3 hours.
While charging a fully discharged battery, the LED will continue to blink until 25% capacity is reached. The LED will then turn solid.
Each of the four LEDs, 25% -100%, will blink as stated above, then turn solid when
the battery reaches it’s capacity
.
When all LEDs illuminate solid, the battery is fully charged and the LEDs will remain solid for a period of time, then all four LEDs will
turn off.
For oxygen concentrators equipped with batteries:
1. When connected to AC or DC pow
er, the unit’s battery charges until it reaches full capacity, either
while the unit is operating or turned off.
2. If the internal battery fully depletes and the Oxygen Concentrator shuts down, the unit cannot be
restarted with the optional AirBelt. Should this occur, connect your Oxygen Concentrator to its AC or
DC power supply for a short period of time in order to provide sufficient internal battery power to start
the unit. AirBelt can then be connected to provide additional run time.
For oxygen concentrators equipped with the optional Airbelt:
1. The AirBelt does not need to be fully discharged before recharging. It is recommended to charge it
after each use.
2. Depending upon the temperature of the AirBelt, it can take several minutes for the charging cycle to
start after connecting to power. This is a normal condition and is intended for safe charging.
For oxygen concentrators equipped with the optional Airbelt:
1. f the AirBelt power supply remains connected when AirBelt is fully charged, the four LEDs will turn off within 15
minutes.
2. Lithium batteries may permanently lose capacity when exposed to extremely hot temperatures with the batteries
fully charged or completely depleted. For extended storage, it is recommended that batteries be charged 25 to
50% and remain within a temperature range of 73°F +/- 35°F (23°C +/- 2°C).