AirSep MN170-1 D - Manual (Page 21)

MN170-1 rev D 17
Charging the Optional AirBelt
To charge
the AirBelt battery for extended use:
1) Release safety cap from end of the AirBelt cord.
2) Connect the Universal AC/DC power supply (included with AirBelt Accessory kit) to the end of AirBelt’s power cord,
as shown in Figure 17.
3) Connect the AirBelt power supply to an AC electrical outlet to recharge.
For oxygen concentrators equipped with the optional Airbelt :
1. The incorrect use of AirBelt can cause the battery to get hot, ignite, and can cause serious injury. Be
sure not to pierce, strike, step on, or drop the battery, or otherwise subject the battery to strong
impacts or shocks.
2. Replace safety cap on AirBelt cord when not in use.
Do not attempt to charge the optional AirBelt with the Focus power supply or the AirBelt can be damaged.
Use only the AirBelt power supply provided to charge AirBelt.
Figure 17: AirBelt Battery Charging set-up
F
i
g
u
r
e
4
AirBelt
PW009-2
AC/DC Power
Supply
F
i
g
u
r
e
4
AC/DC Power Supply
PW009-2 AC/DC Power Supply
F
i
g
u
r
e
4
Connecting the AirBelt cord to the power supply cord
PW009-2 AC/DC Power Supply
F
i
g
u
r
e
4