HP ProLiant DL385 G6 Server - Manual (Page 46)

Hardware options installation 46
7. Install the DIMM.
8. Install the air baffle (" Remove the air baffle " on page 23 ).
9. Install the PCI riser cage (on page 23 ).
10. Install the access panel (on page 22 ).
11. Install the server into the rack.
12. Power up the server (on page 20 ).
For more information about LEDs and troubleshooting failed DIMMs, see "Systems Insight Display LEDs
and internal health LED combinations (on page 9 )."
Hot-plug SAS hard drive options
When adding hard drives to the server, observe the following general guidelines:
• The system automatically sets all device numbers.
• If only one hard drive is used, install it in the bay with the lowest device number (" Hard drive
numbering " on page 15 ).
• Drives should be the same capacity to provide the greatest storage space efficiency when drives are
grouped together into the same drive array.
Installing a hot-plug SAS hard drive
1. Remove the SAS hard drive blank.