HP ProLiant DL385 G6 Server - Manual (Page 43)

Hardware options installation 43
7. Install the TPM board. Press down on the connector to seat the board.
8. Install the TPM security rivet by pressing the rivet firmly into the system board.
9. Install the air baffle.
10. Install the PCI riser cage (on page 23 ).
11. Install the access panel (on page 22 ).
12. Install the server into the rack.
13. Power up the server (on page 20 ).
Retaining the recovery key/password
The recovery key/password is generated during BitLocker™ setup, and can be saved and printed after
BitLocker™ is enabled. When using BitLocker™, always retain the recovery key/password. The recovery
key/password is required to enter Recovery Mode after BitLocker™ detects a possible compromise of
system integrity.
To help ensure maximum security, observe the following guidelines when retaining the recovery
key/password: