HP XP Continuous Access Software User Manual
Page 229
Table 45 Error Codes and Error Contents When Operating RAID Manager (continued)
Error Contents
Error Code
(SSB2)
Error Code
(SSB1)
A request of XP Continuous Access Journal Paircreate was received.
However, the command was rejected because the specified volume was
blocked.
The following programs for OPEN system may not be installed, or the
licenses might be expired:
•
XP Continuous Access Software
•
XP Continuous Access Software Asynchronous
•
XP Continuous Access Journal Software
8F38
A request of XP Continuous Access Journal Paircreate was received.
However, the command was rejected because the XP Continuous Access
Journal program was not installed.
8F39
The XP Continuous Access Journal pair cannot be created because the
cache CL2 is in the abnormal status.
8F46
The XP Continuous Access Journal pair cannot be created because the
cache CL1 is in the abnormal status.
8F47
The XP Continuous Access Journal pair cannot be created or
resynchronized due to the following contributing factors:
•
A journal group is not registered in the secondary storage system.
•
A volume in the journal group which is registered in the secondary
storage system is blocked.
8F4D
A request of XP Continuous Access Journal Paircreate or Pairresync was
received. However, the operation cannot be performed because the load
of the processing was high. Wait about 5 minutes, then retry the operation.
8F50
A request of XP Continuous Access Journal Paircreate was received.
However, the command was rejected because the status of the
configuration could not be transferred.
8F53
A request of XP Continuous Access Journal Paircreate or Pairresync was
received. However, the command was rejected because of one of the
following reasons:
•
The pair status of the specified S-VOL differed from the one of P-VOL.
•
The state of restore journal group differed from the state of master
journal group.
8F58
A request of XP Continuous Access Journal Paircreate was received.
However, the command was rejected because the specified secondary
storage system did not support the external volume.
8F67
A request of XP Continuous Access Journal Paircreate was received.
However, the command was rejected because the specified volume was
a command device.
8F6D
The XP Continuous Access Journal pair cannot be created because the
P-VOL is being used for XP Snapshot.
8FEC
The information for the consistency group cannot be retrieved because
XP Continuous Access Journal was not installed.
B992
The source of command device has run out. Set the command device to
OFF and to ON again from the LUN Manager.
B9C0
XP Continuous Access Journal Paircreate cannot be performed because
the specified device is a command device.
B901
B9E1
Troubleshooting When Using RAID Manager 229