HP StorageWorks Auto Path VA Software - Manual (Page 32)

32 Command-Line User Interface
autopath set device
Set either load balancing policy or preferred path.
Syntax
autopath set device= device_number {policy= policy_name | path= path_number }
• device_number
The device number shown in the autopath devices command-line display.
• policy_name
The name of the load balancing policy. See section ”Setting the Load Balancing Policy” on page 23
for a list of available policies.
• path_number
The preferred path number.
Description
The autopath set device command sets either the load balancing policy or the preferred path for the
device identified by device_number.
Examples
To set load balancing policy:
C:\...\AutoPath\autopath set device=3 policy=Round_Robin
Device Serial No. : 89374856
Controller Port No. : 18
Path Scsi Address : 5.4.1.4
To set preferred path:
C:\...\AutoPath\autopath set device=3 path=2
Change preferred path (y/n) ? y
Preferred Path changed