HP StorageWorks Auto Path VA Software - Manual (Page 27)

Command-Line User Interface 27
Command-Line User Interface
Auto Path VA’s command-line user interface (CLUI) can be used only on hosts that are both connected
to an HP SureStore Virtual Array and have the Auto Path VA driver installed.
You can execute CLUI commands only from the directory where the installed Auto Path VA program
files reside. If you chose the default directory when you performed the Auto Path VA installation,
change the directory to
C:\Program Files\HP\AutoPath , and then execute the CLUI commands.
If you chose a different directory during installation, change the directory to the one you specified, and
then execute the CLUI commands.
The commands supported by Auto Path VA’s CLUI are as follows:
• autopath adapters - Display host bus adapter names.
• autopath devices - Display all devices (LUNs).
• autopath help - Display help for the CLUI commands.
• autopath paths device - Display paths to the specified device.
• autopath set device - Set either the load balancing policy or the preferred path.