HP StorageWorks Auto Path VA Software - Manual (Page 31)

Command-Line User Interface 31
autopath paths device
Display paths to device.
Syntax
autopath paths device= device_number
where device_number is the device number shown in the autopath devices command-line display.
Description
The autopath paths device command displays the paths to the device identified by device_number.
Examples
Example of a device with a load balancing policy:
C:\...\AutoPath\autopath paths device=2
Example of a device with and with out a load balancing policy. An asterisk after the LUN # indicates
the preferred path:
C:\...\AutoPath\autopath paths device=3
Path# Controller Port# State SCSI Port# Bus# TID LUN#
1 18 Active 4 4 1 4
2 3 Active 5 4 1 4
Path# Controller Port# State SCSI Port# Bus# TID LUN#
1 3 Active 4 4 1 3
2 14 Active 5 4 1 3*