HP XP RAID Manager Software - Manual (Page 8)

Table 3 REQUEST operation errors
Corrective action Description Error
N/A Normal noError (0)
Verify that the name of the requested
object is correct. noSuchName (2) •
There are no MIB objects that are required. (Not
supported.)
• The GETNEXT REQUEST command that is specified
for the following object identifier of the last supported
MIB object is received.
SET operation is not supported. SET REQUEST is received. readOnly (4)
Retry the operation. Error occurred for other reasons. genErr (5)
Component status information from SNMP Manager
You can obtain the status information of certain storage system components from the SNMP
Manager. The following table lists the components for which the status can be obtained.
Table 4 Storage system components
Component name Area
Processor(s) Storage System
BUS
Cache
Shared memory
Power supplies
Batteries
Fans
Others
Power supplies Disk Unit
Fans
Hard disks
Others
The following table lists the status of storage system components, as well as the trap report functions.
Table 5 Storage system component status
Description Status
Normal operation. Normal
All operations in a storage system stopped. Acute failure detected
Operation in a component where a failure occurred stopped. Serious failure detected
Partial failure. Moderate failure detected
Minor failure. Service failure detected
8 Introduction