HP Smart Array P600-Controller - Manual (Page 9)

Installing the controller hardware 9
Installing the controller hardware
In this section
Before beginning the installation ................................................................................................................ 9
Preparing the server ................................................................................................................................. 9
Installing the controller board .................................................................................................................... 9
Connecting storage devices..................................................................................................................... 10
Before beginning the installation
Before beginning the installation procedure, visit the HP website ( http://www.hp.com/support ) to confirm
that you have the latest version of each driver and utility file needed. Compare the version numbers of the
files there with those of the same files on the software CD or DVD that is supplied in the controller kit.
Preparing the server
Before installing the controller in the server, back up all data.
If the server supports hot-pluggable devices, no further preparation is required. Proceed to install the
controller board as described ("
Installing the controller board " on page 9 ).
If the server does not support hot-pluggable devices:
1. Close all applications.
2. Power down the server.
CAUTION: In systems that use external data storage, be sure that the server is the first unit to
be powered down and the last to be powered back up. Taking this precaution ensures that the
system does not erroneously mark the drives as failed when the server is powered up.
3. Power down all peripheral devices that are attached to the server.
4. Unplug the AC power cord from the outlet and then from the server.
5. Disconnect all peripheral devices from the server.
Installing the controller board
WARNING: To reduce the risk of personal injury or damage to the equipment, consult the
safety information and user documentation provided with the server before attempting the
installation.
Many servers are capable of providing energy levels that are considered hazardous and are
intended to be serviced only by qualified personnel who have been trained to deal with these
hazards. Do not remove enclosures or attempt to bypass any interlocks that may be provided
for the purpose of removing these hazardous conditions.
1. Remove or open the access panel.