HP Netserver L Server series - Manual (Page 63)

Chapter 8 Installing the NetServer in an HP Rack System/E or Rack System/U
57
9. Remove two screws from each handle and remove the all handles (see
Figure 8-11). Save the handles and screws for future removal and
reshipping of the NetServer.
Figure 8-11. Removing Mounting Handles
Securing the NetServer to the Rack
The following steps secure the NetServer to the rack and install the front bezel.
1. Attach the bezel hinge to the NetServer with three screws through the
right edge of the bezel hinge and into the left front of the NetServer (see
Figure 8-12).
2. Attach the bezel latch to the right side of the NetServer with two screws.