Installing accessory boards – HP Netserver L Server series User Manual

Page 25

Chapter 4

Accessory Boards

NOTE

If you enable NetRAID on only one channel, it is
recommended that you use the default configuration and
enable HP NetRAID on SCSI A. f you enable HP NetRAID on
only one channel, and later want to enable a second channel,
you must follow the instructions in the Integrated HP
NetRAID Controller Configuration Guide in the chapter on
configuring a second channel.

I/0 Memory

SE SCSI

SCSI B

SCSI A

Remote
Management

PCI Board
Slots

ISA Board Slot

Figure 4-2. I/O Board With Devices and Bus Structure

NOTE

For a list of boards HP has tested with the NetServer, see the
Help topic "Tested Parts List" on the HP NetServer Navigator
CD-ROM.

Installing Accessory Boards

Remove cover 1 from the NetServer. (See Chapter 3, "Removing and Replacing
Covers.")

To install accessory boards:

1. Read the documentation included with each accessory board. Follow any

special instructions and installation recommendations. Some boards have