HP Netserver L Server series - Manual (Page 46)

Chapter 6 Installing Mass Storage Devices
40
Locking Latch
Ejector Handle
Locking tab retracts
when the ejector
handle is open
Light Pipes
(fragile)
Figure 6-4. Readying Drive for Installation
4. Slide the drive slowly into the location until it stops (see Figures 6-5
and 6-6).
CAUTION Be careful not to damage the light pipes as you insert the
drive. They are very fragile.
You must insert the drive slowly and gently. If the drive is
inserted too quickly when the system is on, in-rush current
can cause the power supply to shut down.
5. Press the ejector handle in until you feel the latch click into place. Closing
the ejector handle engages the drive with the electrical connector in the
hot-swap mass storage cage and seats the drive. If
the drive is unseated in
the cage after closing the ejector handle, the handle was probably not
pulled out far enough, and the locking latch failed to engage the hot-swap
mass storage cage. Repeat the procedure from step 3.