HP Photosmart Premium TouchSmart Web C309 - Manual (Page 57)

Case A: Separate fax line (no voice calls received)
If you have a separate phone line on which you receive no voice calls, and you have no
other equipment connected on this phone line, set up the HP Photosmart as described
in this section.
Figure 9-1 Back view of the HP Photosmart
1 Telephone wall jack
2 Use the phone cord supplied in the box with the HP Photosmart to connect to the "1-LINE"
port
To set up the HP Photosmart with a separate fax line
1. Using the phone cord supplied in the box with the HP Photosmart, connect one end
to your telephone wall jack, then connect the other end to the port labeled 1-LINE on
the back of the HP Photosmart.
NOTE: If you do not use the supplied cord to connect from the telephone wall
jack to the HP Photosmart, you might not be able to fax successfully. This special
phone cord is different from the phone cords you might already have in your home
or office.
2. From the HP Photosmart touch screen display, access the Fax Settings menu to do
the following:
a. Turn on the Auto Answer setting.
b. (Optional) Change the Rings to Answer setting to the lowest setting (two rings).
c. Run a fax test.
When the phone rings, the HP Photosmart will answer automatically after the number of
rings you set in the Rings to Answer setting. Then it will begin emitting fax reception
tones to the sending fax machine and receive the fax.
Case B: Set up the HP Photosmart with DSL
If you have a DSL service through your telephone company, use the instructions in this
section to connect a DSL filter between the telephone wall jack and the HP Photosmart.
The DSL filter removes the digital signal that can interfere with the HP Photosmart, so
the HP Photosmart can communicate properly with the phone line. (DSL might be called
ADSL in your country/region.)
Chapter 9
54 Fax
Fa
x