HP Scripting Tools for Windows PowerShell - Manual (Page 10)

Table 1 HP iLO Cmdlets for Windows PowerShell (continued)
Description Cmdlet
Configures the Kerberos authentication Set-HPiLOKerberosConfig
Applies a license key for the Integrated Lights-Out Advanced Pack Set-HPiLOLicenseKey
Enable the data-center configuration lock for iLO Set-HPiLOLockConfiguration
Modifies the network settings of the host server where the iLO is located Set-HPiLONetworkSetting
Set One Time Boot Order Set-HPiLOOneTimeBootOrder
Changes the password of a local user Set-HPiLOPassword
Sets the Persistent boot order Set-HPiLOPersistentBootOrder
Set the power alert threshold value for the iLO Set-HPiLOPowerAlertThreshold
Set the Power Cap feature on the host server Set-HPiLOPowerCap
Configures the management processor RBSU to display the IP address during
POST Set-HPiLORBSUPOSTIP
Modifies the current schemaless directory configuration on iLO Set-HPiLOSchemalessDirectory
Assigns the Server Name attribute shown in the user interface and host
RBSU Set-HPiLOServerName
Configures Integrated Lights-Out device to pass network traffic on the shared
host network port Set-HPiLOSharedNetworkPort
Modifies the respective iLO SNMP IM settings Set-HPiLOSNMPIMSetting
Modifies the HP SSO settings for the iLO Set-HPiLOSSOSetting
Toggles the UID on host servers Set-HPiLOUIDStatus
Modifies an existing local user account present in the iLO Set-HPiLOUser
Simulates the physical press of the power button, press and hold of the
power button, cold boot and warm boot of the server Set-HPiLOVirtualPowerButton
Configures the iLO Shared Network Port with a user defined VLAN ID Set-HPiLOVLAN
Sets the Virtual Media drive status Set-HPiLOVMStatus
Configures the virtual media port functionality for the iLO Set-HPiLOVMPortSetting
Initiates Active Health System data submission to the Insight Remote Support
server Start-HPiLOERSAHSSubmission
Initiates an L2 data collection submission to the Insight Remote Support
server Start-HPiLOL2Collection
Initiates a test service event submission to the Insight Remote Support server Start-HPiLOTestEvent
Updates the iLO firmware Update-HPiLOFirmware
Checks if a newer version of the HPiLO Cmdlets is available on the HP
website for download Update-HPiLOModuleVersion
IPv6 support
Consider the following when using IPv6.
•
IPv6 is supported in addition to IPv4 for network addresses on all cmdlets that have an IP
address parameter. The double colon zero subnet format for IPv6 addresses is supported. For
example, 1a00::1fe8 equates to 1a00:0000:0000:0000:0000:0000:0000:1fe8.
•
Address ranges are supported with the dash character. For example, 1a00::1fe8-1fef
resolves to eight addresses from 1a00::1fe8 through 1a00::1fef.
10 HP Scripting Tools for Windows PowerShell cmdlets