HP ProLiant SL4540 Gen8 Server - Manual (Page 42)

Hardware options installation 42
5. Install the TPM board. Press down on the connector to seat the board (" System board components " on
page 8 ).
6. Install the TPM security rivet by pressing the rivet firmly into the system board.
7. Install the access panel (on page 23 ).
8. Install the node into the chassis (" Installing a node into the chassis " on page 27 ).
9. Power up the node (" Powering up and configuring the server " on page 28 , " Powering up the system "
on page 21 ).
Retaining the recovery key/password
The recovery key/password is generated during BitLocker™ setup, and can be saved and printed after
BitLocker™ is enabled. When using BitLocker™, always retain the recovery key/password. The recovery
key/password is required to enter Recovery Mode after BitLocker™ detects a possible compromise of system
integrity.
To help ensure maximum security, observe the following guidelines when retaining the recovery
key/password: