HP StorageWorks XP Remote Web Console Software User Manual
Page 75
4.
Click Go, TrueCopy for Mainframe, and then RCU Operation on the menu bar of the Remote
Web Console main window to display the TrueCopy for Mainframe window (RCU Operation
window is displayed).
5.
Configure the Fibre Channel ports which are connected to the RCUs as initiator ports (see
“Configuring the RCU Target and Initiator Ports” (page 76)
).
6.
Add the desired RCU(s) to each MCU CU, and set the desired RCU options using the Add
RCU dialog box (see
) and RCU Option dialog box (see
“Configuring the RCU Options” (page 78)
). Enter the following information on the Add RCU
dialog box:
Enter the Following Information in the Field
RCU Options
Serial number of the RCU
RCU S/N
The number of LDKC which the RCU belongs to (00 or 01)
LDKC
For Fibre Channel, the controller ID must be 5 (4 for XP12000/XP10000 Disk
Array/NSC, 03 for XP1024/XP128 Disk Array)
Controller ID
RCU CU number (00–FE for XP24000/XP20000 Disk Array, 00–3F for
XP12000/XP10000 Disk Array/NSC, 00–1F for XP1024/XP128 Disk Array)
Logical Adr. (RCU CU)
Maximum of four SSIDs per CU with 64 LDEVs per SSID
If only one SSID is specified, there are 256 LDEVs per SSID.
SSID
Physical port numbers (1A-2R) for each path (initiator port-to-RCU target port.
MCU-RCU path
7.
If you plan to create TrueCopy for Mainframe Asynchronous pairs with M-VOLs in this MCU,
configure the Async options (see
“Setting the Async Options” (page 78)
), and add the desired
consistency group(s) to the MCU (see
“Adding the Consistency Groups” (page 79)
).
8.
When you are finished configuring this MCU, exit the TrueCopy for Mainframe software, and
disconnect from the storage system.
9.
Repeat steps 3−8 for each storage system which will function as a TrueCopy MCU. After you
have configured the MCUs, added the RCUs, and configured the TrueCopy Async options
and consistency groups, you are ready to begin TrueCopy pair operations.
Configuring the MCUs and RCUs for TrueCopy for Mainframe Operations
75