HP LeftHand P4000 SAN Solutions - Manual (Page 32)

32 | HP StoreVirtual CLI | Commands
remoteUserName=admin remotePassWord=secret
remoteCluster="10.0.1.21"
cliq createRemoteSnapshot primarySnapshot=Snapshot0
remoteSnapshot=Snapshot0 remoteVolume=Volume0
description="Exchange DB-1"
remote=10.1.2.4 remoteUserName=admin remotePassWord=secret
remoteCluster="10.0.1.21"
createServer
This command creates a representation of a client server in a management group. This "server" can be
associated with iSCSI or FibreChannel initiators and be granted access to volumes.
Availability: Windows, SSH
Version: 9.0
Request Syntax
cliq createServer serverName= useCHAP= initiator= login= userName= passWord=
login Required The IP addresses or DNS-resolvable names of one or more storage
systems
userName Conditional The authentication user name for the storage system. (Parameters
userName/passWord or groupName must be specified).
passWord Conditional The password for the storage system. (Parameters userName/passWord
or groupName must be specified).
groupName Conditional The name of the management group with cached credentials.
(Parameters userName/passWord or groupName must be specified).
serverName Required The name of the server
description Optional Optional description
allowiSCSIAccess Optional Allow iSCSI access for this host. This can be one of: 0 = disable or 1 =
enable. If volumes are attached to a client server via iSCSI and a value
of 0 is entered, the client server will lose its ability to communicate with
the attached volumes. If an IQN is entered and FibreChannel is NOT
configured, the default will be 1, otherwise no default will be selected.
vipLoadBalance Optional Use VIP load balancing for this host. This can be one of: 0 = disabled
or 1 = enabled, 1 is the default.
useCHAP Optional Use CHAP Authentication this host. This can be one of: 0 = disabled or
1 = enabled.
initiator Optional A semicolon delimited string of host IQN's. Valid characters are any
letter, number, international character or '-', '.' and ':' characters.
targetSecret Optional The CHAP target secret for the volume.
chapName Optional The CHAP name for the volume. If this is not specified, the IQN of
the local server is used (this parameter is required if run on a storage
system).
initiatorSecret Optional The CHAP initiator secret for the volume.
controllingserver Optional Enter the IP address of the client server that has Application Aware
Snapshot Manager (AASM) installed on it. It will coordinate the
snapshot with the applications using SAN volumes. This is required
for managed snapshots of FibreChannel connected volumes. This is
also required for VMware managed snapshots, enter the Virtual Center
Server IP address.
allowfcaccess Optional Allow FibreChannel ports to be assigned to the client. This can be one
of: 0 = disable or 1 = enable. If volumes are attached to a client server