Changing the scsi ids, Scsi ids:changing, Ready – HP Surestore 660ex Optical Jukebox User Manual
Page 57: Note if you are unfamiliar with basic scsi address, Start with, Press, Enter the administration password, Instructions for entering this password are in “en, View id’s, Bus 1

Chapter 3
3-17
Operating the Jukebox
Setting the SCSI IDs
Op
eratin
g th
e
Ju
kebo
x
Changing the Current SCSI IDs
READY
>
ADMIN *
>
SCSI ID’S *
>
SET ID’S *
NOTE
If you are unfamiliar with basic SCSI addressing or LUN addressing, refer to
Appendix B. A web site is also available for more extensive information at:
www.hp.com/isgsupport/optical/index.html.
Start with
READY
in the display.
1. Press
NEXT
until
ADMIN *
displays, and then press
ENTER
.
2. Enter the administration password.
Instructions for entering this password are in “Entering the Administration
Menu Password” previously in this chapter.
3. Press
NEXT
until
SCSI ID’S
displays, and then press
ENTER
.
4.
VIEW ID’S
displays. Press
NEXT
until
SET ID’S
displays and then press
ENTER
.
BUS 1 *
displays. If you want to change the IDs on Bus 1, press
ENTER
.
If you want to change the IDs on Bus 2, press
NEXT
until
BUS 2 *
displays and
then press
ENTER
.
If you are using basic SCSI addressing (LUN mode OFF):
JKBX ID # LUN #
or
DRV # ID # LUN #
displays. (
JKBX ID #
stands for the current ID of the jukebox controller,
LUN #
is the current logical
unit number, and
DRV # ID #
is the current ID setting for the displayed drive
number.) When using basic SCSI addressing, the
LUN #
is always
0
.
If you are using LUN addressing (LUN mode ON):
JKBX BUS 1 #
or
DRVs BUS 1 #
displays on Bus 1, or
DRVs BUS 2 #
displays on Bus 2. (“
#
” is the current ID for the jukebox controller and drives
when LUN mode is ON.)
5. Press
NEXT
until the setting you wish to change displays, and then press
ENTER
.
The
#
(current ID) begins flashing.