HP Surestore 660ex Optical Jukebox - Manual (Page 79)

Chapter 3 3-39
Operating the Jukebox
Troubleshooting
Op
eratin
g th
e
Ju
kebo
x
Disk eject attempted but
RESERVED displays.
The jukebox application software reserved the
element for its use or a security configuration was set
to prevent disk ejection.
• If appropriate, change this setting See “Setting an
Operating Configuration” in this chapter. The
current administration password is required.
Disk eject attempted but
empty and then
EJECT *
displays.
This is not an error. There are no disks in the
jukebox.
Disk eject attempted but
TRANSPORT FULL
displays.
The disk transport mechanism already contains a
disk.
• Refer to your host and application documentation
for recovery procedures. If no procedures are
available, call your service representative.
Disk eject attempted but
SOURCE NOW EMPTY
displays.
The application software moved the disk from the
slot you chose before your eject command executed.
• Press CANCEL
. You may have to wait for the
application to replace the disk into the slot
before attempting another eject.
Disk eject attempted but
MAILSLOT FULL
displays.
A disk is in the mailslot.
• Remove the disk from the mailslot.
Select EJECT * , select the slot you want the
disk ejected from again, and eject the disk.
You want to stop a test
that is running. Press CANCEL . The current test loop continues until
finished, then the test stops.
*Ensure that the SCSI bus is inactive before removing power to the jukebox.
Removing power to a device on an active SCSI bus can cause data loss and/or
problems with the SCSI interface.
Problem What to do