Figure 1-4 connecting a 10-drive jukebox, one host, Terminate the daisy-chained bus by plugging a t, A differential interface port uses a 68-pin high-d – HP Surestore 660ex Optical Jukebox User Manual
Page 27: The same cabling can be done using the single-ende, Caution do not daisy-chain between single-ended an, Plug a scsi terminator into one of scsi ports o, Use a 50-pin high-density active terminator for th, To continue with the installation, go to “conne, Bus 1 and 2 daisy-chained, lun addressing -15
Chapter 1
1-15
Setting Up the Jukebox
Connecting a 10-Drive Jukebox, One Host Adapter, Bus 1 and 2
Daisy-Chained, LUN Addressing
Ch
ap
ter
1
: Setti
ng
up
the Disk Driv
e
S
ettin
g Up
th
e
Ju
kebo
x
Figure 1-4
Connecting a 10-Drive Jukebox, One Host Adapter,
Bus 1 and 2 Daisy-Chained, LUN Addressing
5.
Terminate the daisy-chained bus by plugging a terminator into the
unused port of the second interface (the diagram show the terminator in
port “B1”). In this example you would use a 68-pin differential
terminator in “B1.”
A differential interface port uses a 68-pin high-density terminator. A
single-ended interface port uses a 50-pin high-density terminator.
The same cabling can be done using the single-ended ports.
CAUTION
Do not daisy-chain between single-ended and differential interfaces.
6.
Plug a SCSI terminator into one of SCSI ports on each unused interface
(the example diagram shows the terminators on the single-ended port at
“A2” for both interfaces). The terminators can be placed on either port of
the unused interface.
Use a 50-pin high-density active terminator for the single-ended interface
or a 68-pin terminator for the differential interface.
7. To continue with the installation, go to “Connecting Power” in this Chapter.