Connecting:4- or 6-drive jukebox, Caution make sure that all peripheral devices conn, Removing the customer access panel – HP Surestore 660ex Optical Jukebox User Manual
Page 21: Switch off power to the host computer before yo, Note the jukebox ships from the factory with two s, These screws may not have been replaced, It is a good idea to use the screws to secure the, If you have to replace these screws, they are 6/32, Remove the customer access panel by pulling on, Connecting a 4- or 6-drive jukebox -9
Chapter 1
1-9
Setting Up the Jukebox
Connecting a 4- or 6-Drive Jukebox
Ch
ap
ter
1
: Setti
ng
up
the Disk Driv
e
S
ettin
g Up
th
e
Ju
kebo
x
Connecting a 4- or 6-Drive Jukebox
CAUTION
Make sure that all peripheral devices connected to the host computer have been
properly shut down. If the host computer is connected to a network, check with the
system administrator before switching off power.
Removing the Customer Access Panel
1. Switch off power to the host computer before you connect the jukebox
NOTE
The jukebox ships from the factory with two screws securing the bottom of the
customer access panel to the side of the jukebox. These screws are removed during
the process of unpacking and removing the jukebox from the shipping pallet.
These screws may not have been replaced.
It is a good idea to use the screws to secure the access panel to the jukebox since
they must be in place if the jukebox is ever reshipped.
If you have to replace these screws, they are 6/32 x .437.
2. Remove the customer access panel by pulling on the bottom of the panel and
then lifting it off (see Figure 1-1). (If screws are installed, use a flatblade
screwdriver or T-15 Torx driver.)