HP XP P9000 Auto LUN Software - Manual (Page 53)

•
“Recreating auto migration plans ” (page 25)
•
“Stopping the Auto Migration function” (page 26)
The Auto Plan window contains Auto Migration Plans and Auto Plan Parameters sections and is
used to set up, configure, and manage Auto Migration. The following table describes all fields,
options, and buttons on this window.
Description Type Item
Auto Migration Plans section
The value in this field is either Enable or Disable and indicates whether
or not the Auto Migration function is enabled. field Auto Migration
Indicates the status of the auto migration plans. This field can have
the following values: field Migration Status
• Not planned yet: the auto migration plans have yet to be created.
•
Not performed yet: the auto migration plans have been created
but have yet to be executed.
• Failed to make a plan: Auto LUN has failed to create the auto
migration plans.
•
Under migration: Auto LUN is executing auto migration plans.
•
Last migration has been canceled: Auto LUN has canceled the last
auto migration plan.
A timestamp indicating when the auto migration plans were created. field Plan Creation
A timestamp indicating when Auto LUN will perform the next auto
migration operations. field Next Migration
The possible values for Auto Refresh are Enable and Disable. If Auto
Refresh is enabled, the progress of migration plans are updated in option buttons Auto Refresh
real time, and if a new plan is created, the new plan will automatically
be added to the list. If Auto Refresh is disabled, information in the list
will not be updated automatically.
NOTE: The time values displayed on this window are retrieved from
the SVP, and may not correspond to the time displayed on the Remote
Web Console web client.
Discards the existing auto migration plans and then creates new auto
migration plans. button Make New Plan
Deletes the auto migration plan selected in the list and all auto
migration plans below the selected plan in the list. button Delete
Deletes all auto migration plans in the list. button Delete All
Indicates the progress of the auto migration plans. A hyphen appears
if Auto LUN has yet to execute the auto migration plans. field %
The following information is displayed for the Source LDEV: list Source LDEV
• LDEV: the ID of the volume is displayed in the following format:
LDKC
:CU:LDEV.
•
Emulation: the emulation type of the volume.
• Capacity: the capacity of the volume.
•
RAID: the RAID type of the volume.
• Protection: the data protection level.
•
PG: the parity group ID. If the indicated parity groups are the
interleaved parity groups, the only parity group ID displayed will
be that of the group at the top of the interleaved parity groups.
•
HDD: the type of hard disk drive.
Auto Plan window 53