HP UPS Extended Runtime Module - Manual (Page 42)

Troubleshooting 42
Off Flashin
g red Off Off Flashin
g red Off On—1 beep
every 5
seconds Yes On battery—Input
voltage is out of range
(on page
43 )
Flashing
red Flashin
g red Flashin
g red Flashin
g red Flashin
g red Flashing
red On—
Continuous No Internal UPS fault
condition (on page
44 )
Red Off Off Off Off Off On—
Continuous Yes Self-test failure
("
Battery condition "
on page 43 )
Flashing
red Off Off Off Flashin
g
green Off On—
Continuous Yes REPO condition (on
page
44 )
Off Off Off Red Off Off On—1 beep
every 5
seconds Yes Site wiring condition
(on page
44 )
Flashing
red Off Off Off Off Red On—
Continuous Yes UPS power capacity is
exceeded ("
Overload
condition " on page
44 )
For the location of individual LEDs, see "UPS front panel LED indicators (on page 8 )."
UPS is in Auto-Bypass mode
Action:
1. If power management software is being used, check the log files to obtain specific error information
to help identify the problem.
For more information about the causes of a general fault condition, see the HP Power Manager user
guide available for download from the HP website (
http://www.hp.com/go/rackandpower ).
2. Verify that no blockage of airflow to the front bezel and rear panel exists.
3. If the LED does not turn off, replace the electronics module. (" Replacing the UPS electronics module "
on page 33 )
General alarm condition
Action:
1. If power management software is being used, check the log files to obtain specific error information
to help identify the problem.
For more information about the causes of a general alarm condition, see the HP Power Manager
user guide available for download from the HP website (
http://www.hp.com/go/rackandpower ).
2. Check the batteries:
a. Allow the UPS batteries to charge for 24 hours.
b. If the Battery Fault LED is red, replace the batteries (" UPS battery replacement procedure " on
page 36 ).
3. Reduce the load:
a. Power down the UPS (" Powering down the UPS " on page 31 ).