HP 3PAR InForm Operating System Software - Manual (Page 32)

Host Settings
1. In the General group box:
a.
System - Select the system to create the new host.
b. Domain - Select the domain in which to create the new host. Select if not
applicable.
c. Name - Enter the host name. Names are case-sensitive.
d. Set Name - Select the host set in which to create the new host. Select if not
applicable.
e. Host OS - Select the operating system running on the host.
f. Persona - The host persona is visible and disabled. When you select Host OS, the
corresponding persona is selected for the user, and the Operating System descriptor field
is automatically populated with the host OS.
•
1 = Generic (Unit Attention Report LUNs, Enable SES device)
•
2 = Generic-ALUA (Unit Attention Report LUNs, Report Target Port Groups, Enable
SES device)
•
6 = Generic-legacy
•
7 = HPUX-legacy (Volume Set Addressing)
•
8 = AIX-legacy (Normal Auto Contingent Allegiance)
•
9 = Egenera (Soft Inquiry Data)
•
10 = ONTAP–legacy (Soft Inquiry Data)
•
11 = VMware (Enable Sub-LUN Addressing, Asymmetric Logical Unit Access)
2. (Optional) In the Descriptors group box, enter the description information as desired in the
Location, IP Address, Operating System, Model, Contact, and Comments fields.
3. Click Next or Finish to close the wizard and create the host with the information that you
entered.
Fibre Channel Settings
1. To assign available WWNs:
a.
Select one or more WWNs from the Available WWNs list. This list displays WWNs for
all physically connected host paths not already assigned to hosts.
b. Click the left arrow to add the selected WWNs to the Assigned WWNs list.
2. To assign new WWNs, enter the WWNs for the host in the New WWN field, then click Assign.
3. Click Next or Finish to close the wizard and create the host with the information entered.
iSCSI Settings
1. In the iSCSI Host Paths group box:
a.
Select one or more iSCSI names from the Available iSCSI Names list. This list displays
iSCSI names for all physically connected host paths not already assigned to hosts.
b. Click the left arrow to add the selected iSCSI names to the Assigned iSCSI Names list.
c. To assign new iSCSI names, enter the iSCSI names in the New iSCSI Name field, then
click Assign.
2. In the CHAP group box:
a.
Click to select the Initiator CHAP checkbox. The CHAP Name field displays the host name.
b. Enter a secret/password in the CHAP Secret field for Initiator CHAP.
If the secret/password is hexadecimal, click to select the Hex checkbox.
32 Configure Storage