HP 3PAR InForm Operating System Software - Manual (Page 24)

iSCSI Connections
To set up iSCSI connections:
•
Verify that your network supports 10-GB iSCSI connections.
•
Connect the host system to the HP 3PAR StoreServ Storage system using multiple paths to
ensure that your HP 3PAR storage system remains available if a path fails.
Configuring iSCSI Connections
To access the iSCSI Host Configuration wizard and configure iSCSI connections, click the Configure
iSCSI host link in the SmartStart wizard.
For more information, see “Configure the iSCSI Host” (page 27) .
Configure the Fibre Channel Host
Introduction to Configuring the Fibre Channel Host
To set up Fibre Channel connections, ensure that the host system and HP 3PAR StoreServ 7000
Storage system have two Fibre Channel connections. You can configure the Fibre Channel host if
you have only one connection, but if that connection stops functioning, the host will not be able to
access (read from or write data to) the HP 3PAR StoreServ Storage system.
For more information about setting up Fibre Channel connections, see the HP 3PAR Windows
Implementation Guide. To access this document, go to the HP 3PAR StoreServ Storage site and
click the Support link for your product:
http://www.hp.com/go/3par
CAUTION: The Fibre Channel Host Configuration wizard might require a reboot of the host
system. If the host system cannot be rebooted at this time, use the Fibre Channel Host Configuration
wizard to configure your Fibre Channel connections when a possible reboot is more convenient.
24 Configure the Hosts