HP StoreFabric Converged Network Adapters User Manual
Page 40
Configuration 40
To set the IP address of the iSCSI HBA for iSCSI offload:
1.
Click the name of the iSCSI device in the SCSI controller section of the Explorer View pane.
2.
To set the IP address, do one of the following:
o
For IPv4 DHCP and IPv6 DHCP protocols, select Enable to set the IP address dynamically using a
DHCP server (not available for iSCSI booted adapters).
o
For other protocols, select Disable to set the IP address using a static IP address.
3.
Enter values for the IP Address, Subnet Mask, and Default Gateway.
4.
Configure the VLAN ID for the iSCSI HBA by entering a number for VLAN ID. The value must be between
0 and 4094.
5.
After the configurations are complete, click Apply to save the settings. Or, click Reset to revert to the
previous settings.