HP StoreFabric Converged Network Adapters - Manual (Page 33)

Configuration 33
• Management Firmware indicates the version installed on the system.
• Vendor ID indicates the vendor ID.
• Device ID indicates the adapter ID.
• Subsystem Vendor ID indicates the subsystem vendor ID.
• Subsystem ID indicates the subsystem ID.
• External PHY Firmware Version indicates the external PHY firmware version.
Configuring adapter parameters
Select the network adapter in the Explorer View pane, and then select the Configuration tab to configure
adapter-level parameters.
Configuring multi-function parameters
Click Configure to configure multi-function parameters.
Hardware and resource configuration wizard
To modify device hardware and resource configurations with the Hardware and Resource Configuration
Wizard:
1. Select a port to configure, and then click Next.
2. Configure the options:
o Flow Control values are Auto, Tx Pause, Rx Pause, Tx/Rx pause, and Disable. The configuration is
done at the port level and applies to all functions under the port. The flow control value is a default
value for the port. The effective configuration can be different based on the switch port configuration
and whether or not DCB/DCBX is enabled.
o Link Speed configures the link speed.
o Ethernet/NDIS enables Ethernet/NDIS capability.
o iSCSI enables iSCSI functionality.
o FCoE enables FCoE functionality.
3. Click Apply to commit changes to the system or click Cancel. Click Finish to save the changes and exit
the wizard.
Managing the Ethernet controller (port)
To manage the Ethernet controller (port):
From BACS, group various traffic classes into a priority group, and then allocate bandwidth to each priority
group.
Select the Ethernet controller from the object explorer panel to view the Information and Configuration tabs.
Viewing port level information
To view various types of information at the port level: