HP ProLiant SL390s G7 Server - Manual (Page 26)

Hardware options installation 26
7. Lift the drive assembly out of the tray.
8. Rotate the drive carrier handle down.
9. Lock the drive carrier latches.
10. Install the server into the chassis (" Installing the server into the chassis " on page 21 ).
11. Connect the peripheral devices to the server.
12. Power up the server (" Powering up and configuring the server " on page 23 ).
Processor options
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
CAUTION: To prevent possible server malfunction and damage to the equipment, multiprocessor
configurations must contain processors with the same part number.
CAUTION: To prevent possible server overheating, always populate processor socket 2 with a
processor and a heatsink or a processor socket cover and a heatsink blank.
IMPORTANT: Processor socket 1 must be populated at all times or the server does not function.
To install the component:
1. Power down the server (on page 15 ).
2. Disconnect all peripheral cables from the server.
3. Remove the server from the chassis (on page 15 ).
CAUTION: Failure to completely open the processor locking lever prevents the processor from
seating during installation, leading to hardware damage.