HP StoreEver MSL Tape Libraries - Manual (Page 59)

When the Libraries are separated, each Library will need its own key server token with the keys to
read tapes that were written by the extended Library.
To create a second key server token with the keys used by the extended library, follow the instructions
for backing up the key server token data in the HP StorageWorks 1/8 G2 and MSL Encryption Kit
user guide.
Insert the key server token into the USB port on the master Library.
Reconfiguring the Libraries
When extended mode is disabled, each Library will have a mix of settings from the extended library,
default values, previous values, and new values. Use the OCP or RMI to check the settings for each
Library and reconfigure them if necessary. See the HP StorageWorks MSL2024, MSL4048, and
MSL8096 Tape Libraries user and service guide for more information about the settings and configuring
the Libraries.
Settings retained from the extended library
The following settings are retained by both Libraries from the extended library:
• Administrator password
• SCSI tape drive addresses
• Fibre Channel drive settings
• Date and time
• Email notification
• Encryption — remains On if LTO3 or LTO4 tape drives are installed
Settings that are set to default values
The following settings are set to default values:
• Mailslot configuration — all mailslots disabled
• Reserved slots — no reserved slots
• Library mode — Automatic
• Autoload — No
• Loop — No
• Logical libraries (partitioning) — Off
• SCSI master drive — the lowest tape drive in each Library
Settings where the lower Library reverts to earlier values
For the following settings, the upper Library retains the settings from the extended Library and the
lower Library reverts to the settings it had before extended mode was enabled:
• Network settings
• Barcode format reporting
• Auto clean
• SNMP
• Log tracing configuration
• Allow magazine access without the Administrator password
• Ignore barcode media ID
HP StorageWorks MSL Library Extender user guide 59