HP StorageWorks XP Remote Web Console Software - Manual (Page 36)

Table 2 Host Mode Options
When to select this option Host mode options No.
When VERITAS Database Edition/Advanced Cluster for Real Application Clusters
or VERITAS Cluster Server 4.0 or later (I/O fencing function) is used VERITAS Database
Edition/ Advanced
Cluster 2
When all the following conditions are satisfied:
• The host mode 0C Windows or 2C Windows Extension is used
•
The Emulex host bus adapter is used
• The mini-port driver is used
•
TPRLO=2 is specified for the mini-port driver parameter of the host bus
adapter
TPRLO 6
When all the following conditions are satisfied:
• The host mode 00 Standard or 09 Solaris is used
•
SUN StorEdge SAN Foundation Software Version 4.2 or better is used
• You want to automate recognition of increase and decrease of devices when
genuine SUN HBA is connected
Automatic recognition
function of LUN 7
When all the following conditions are satisfied:
•
The host mode 08 HP is used
• You want to suppress creation of device files for devices to which paths are
not defined.
No display for ghost
LUN 12
When you want to be informed by SIM (service information message) that the
number of link failures detected between ports exceeds the threshold SIM report at link failure 13
1
When all the following conditions are satisfied:
• The host mode 07 Tru64 is used
•
You want to use TruCluster to set a cluster to each of P-VOL and S-VOL for
XP Continuous Access or HP StorageWorks XP Continuous Access Journal
Software.
HP TruCluster with XP
Continuous Access
function 14
When all the following conditions are satisfied:
• The host mode 0F AIX is used
•
HACMP 5.1 Version 5.1.0.4 or later, HACMP4.5 Version 4.5.0.13 or later,
or HACMP5.2 or later is used
HACMP 15
When Veritas Cluster Server is used. Veritas Cluster Server 22
When you want to shorten the recovery time on the host side if the data transfer
failed. REC Command Support 23
1
When all the following conditions are satisfied:
• The host mode 03 HP or 05 OpenVMS 2 is used.
•
You want to enable commands to assign a nickname of the device.
• You want to set UUID to identify a logical volume from the host
Set/Report Device
Identifier enable 33
When all the following conditions are satisfied:
• The host mode 05 OpenVMS or 07 Tru64 is used
•
You want to set UUID to identify a logical volume from the host.
UUID Option 34
In case that you want to control the following ranges per host group when
receiving Target Reset:
•
Range of job resettings
•
Range of UAs (Unit Attentions) defined
Change the nexus
specified in the SCSI
Target Reset 39
36 Performing LUN Manager Operations