HP USB Hybrid ATSC NTSC QAM FM TV Tuner - Manual (Page 35)

Using the remote control
To use the remote control, follow these steps:
1. Be sure that the remote control batteries are installed. Refer to Inserting or replacing the remote
control batteries on page 32 , later in this chapter.
2. Be sure that the remote sensor is connected to the computer. Refer to Chapter 3, TV tuner setup
on page 6 , for details.
3. Turn on the computer.
4. Point the remote control at the remote sensor to use it to control the TV tuner.
NOTE: The remote sensor should be located in a convenient place. Be sure that nothing
blocks the path between your remote control and the remote sensor.
The remote control must be pointed at the remote sensor when any button is pushed for the TV tuner
to receive the signal.
Using the remote control 31