HP USB Hybrid ATSC NTSC QAM FM TV Tuner User Manual
Page 15
To connect the TV tuner to your existing satellite TV or cable TV source with a receiver, follow these
steps:
1.
Connect an RF coaxial cable (purchased separately) from your cable or satellite TV wall jack (1)
to the TV-in jack on your cable or satellite receiver (2).
2.
Connect an RF coaxial cable (purchased separately) from the TV-out jack (3) on your cable or
satellite receiver to the TV tuner (4).
NOTE:
For improved video quality you can connect your receiver to the TV tuner using a
composite video or S-Video cable instead of an RF coaxial cable. Refer to Chapter 4,
, for instructions.
3.
Insert the TV tuner into a USB port (5) on the computer.
NOTE:
Due to power and bandwidth requirements, do not insert the TV tuner into a USB hub.
4.
Connect the remote sensor to a USB port on the computer. Refer to
sensor and infrared (IR) emitter cable on page 12
, for details.
NOTE:
For additional connection steps, such as adding a television, refer to Chapter 4,
.
Step 4: Set up your audio/video connection
11