HP LD4235 41.92-inch LED Digital Signage Display - Manual (Page 107)

Transmission
[d][f][ ][Set ID][ ][Data][Cr]
Data
0 to 32: 0 (Bottom) to 50 (Top)
* Bottom/Top values depend on Tile Vertical size.
** It may not be supported depending on the model.
Acknowledgement
[f][ ][Set ID][ ][OK/NG][Data][x]
42. Tile H Size (Command: d g)
To adjust the Tile Horizontal size.
*Set Tile H Position to 0x32 before setting Tile H Size.
* This function is available only when the Natural option of the Tile Mode is set to Off while the Tile Mode set
to On.
Transmission
[d][g][ ][Set ID][ ][Data][Cr]
Data
00 to 32: 0 to 50
Acknowledgement
[g][ ][Set ID][ ][OK/NG][Data][x]
43. Tile V Size (Command: d h)
To adjust the Tile Vertical size.
*Set Tile V Position to 0x00 before setting Tile V Size.
* This function is available only when the Natural option of the Tile Mode is set to Off while the Tile Mode set
to On.
Transmission
[d][h][ ][Set ID][ ][Data][Cr]
Data
00 to 32: 0 to 50
** It may not be supported depending on the model.
Acknowledgement
[h][ ][Set ID][ ][OK/NG][Data][x]
44. Natural Mode (In Tile Mode) (Command : d j)
To display the image naturally, the part of the image that would normally be displayed in the gap between
the displays is omitted.
Transmission
Transmission / Receiving protocol 97