HP Color LaserJet CP2025 Printer series - Manual (Page 109)

Control-panel message Status alert Description Recommended action
away from you and then press
OK .
Manual feed
Press [OK] for available media
The product is set for manual
feed mode. Press OK to clear the message
or load the correct media into
tray 1.
Memory is low
Press [OK]
Try again later or turn off & on
The product memory is almost
full. Press OK to finish the job, or
press X to cancel the job.
Break the job into smaller jobs
that contain fewer pages.
For information about increasing
the product memory, see
Install
memory and font DIMMs
on page 86
.
Misprint
Press [OK]
Print media has been delayed as
it moves through the product. Press OK to clear the message.
Non HP supply installed A non-HP supply is installed. This message is temporary and
will disappear after several
seconds.
If you believe you purchased an
HP supply, go to
www.hp.com/
go/anticounterfeit .
Service or repairs that are
required as a result of using non-
HP supplies are not covered
under HP warranty.
Order cartridge The identified print cartridge is
nearing the end of its useful life. Order the identified print
cartridge. Printing will continue
until Replace cartridge
appears.
See Supplies and accessories
on page 125 for more
information.
Order supplies More than one supply item is low. Check the supply-level gauges
on the control panel, or print a
Supplies status page to
determine which cartridges are
low. See
Information pages
on page 68 .
Order the identified print
cartridges. Printing will continue
until Replace cartridge
appears.
See Supplies and accessories
on page 125 for more
information.
Print failure
Press [OK] If error repeats turn
off then on
The product cannot process the
page. Press OK to continue printing the
job, but output might be affected.
ENWW Control-panel and status-alert messages 99