Connecting switch attach configurations, Connecting remote management hosts, Dual controller configurations – HP P2000 G3 MSA Array Systems User Manual
Page 39: One server/one hba/dual path, Two servers/one hba per server/dual path, Dual controller configuration, Two servers/two switches
HP P2000 G3 FC MSA System User Guide
39
Dual controller configurations
One server/one HBA/dual path
Two servers/one HBA per server/dual path
Connecting switch attach configurations
Dual controller configuration
Two servers/two switches
Connecting remote management hosts
The management host directly manages systems out-of-band over an Ethernet network.
1.
Connect an RJ-45 Ethernet cable to the network management port on each P2000 G3 MSA System
controller.
2.
Connect the other end of each Ethernet cable to a network that your management host can access
(preferably on the same subnet).
NOTE:
Connections to this device must be made with shielded cables – grounded at both ends – with
metallic RFI/EMI connector hoods, in order to maintain compliance with FCC Rules and Regulations.
6Gb/s
6Gb/s
Server
6Gb/s
6Gb/s
Server 1
Server 2
6Gb/s
6Gb/s
Server 1
Server 2
Switch A
Switch B