HP ProLiant ML350p Gen8 Server - Manual (Page 83)

Hardware options installation 83
The server exits standby mode and applies full power to the system. The system power LED changes
from amber to green.
18. Do one of the following:
o For tower models, install the bezel.
o For rack models, if removed, install the security bezel (on page 21 ).
For more information about the storage controller and its features, select the relevant controller user
documentation on the HP website (
http://www.hp.com/go/smartstorage/docs ).
To configure arrays, see the HP Smart Storage Administrator User Guide on the HP website
( http://www.hp.com/go/smartstorage/docs ).
Installing the cache module and FBWC capacitor pack
CAUTION: The cache module connector does not use the industry-standard DDR3 mini-DIMMs.
Do not use the controller with cache modules designed for other controller models, because the
controller can malfunction and you can lose data. Also, do not transfer this cache module to an
unsupported controller model, because you can lose data.
To install the component:
1. Do one of the following:
o For tower models, open and remove the bezel (" Remove the tower bezel " on page 21 ).
o For rack models, if installed, remove the security bezel (on page 21 ).
2. Power down the server (on page 20 ).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
o For tower models, place the server on a flat, level surface with the access panel facing up.
o For rack models, extend the server from the rack (on page 24 ).
5. Remove the access panel (on page 23 ).
6. Remove the air baffle (on page 25 ).
7. Remove the fan cage.