HP ProLiant ML350p Gen8 Server - Manual (Page 73)

Hardware options installation 73
o For tower models, open and remove the bezel (" Remove the tower bezel " on page 21 ).
o For rack models, if installed, remove the security bezel (on page 21 ).
2. Remove the drive blank.
Installing a hot-plug drive
WARNING: To reduce the risk of injury from electric shock, do not install more than one drive
carrier at a time.
The server can support six drives in a LFF configuration, or eight drives in a SFF configuration.
To install the component:
1. Do one of the following:
o For tower models, open and remove the bezel (" Remove the tower bezel " on page 21 ).
o For rack models, if installed, remove the security bezel (on page 21 ).
2. Remove the drive blank.