HP ProLiant ML350p Gen8 Server - Manual (Page 28)

Operations 28
To remove the component:
1. Do one of the following:
o For tower models, open and remove the bezel (" Remove the tower bezel " on page 21 ).
o For rack models, if installed, remove the security bezel (on page 21 ).
2. Power down the server (on page 20 ).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
o For tower models, place the server on a flat, level surface with the access panel facing up.
o For rack models, extend the server from the rack (on page 24 ).
5. Remove the access panel (on page 23 ).
6. Remove the air baffle (on page 25 ).
7. Remove the fan cage.
Remove the optical drive
The server supports both DVD-ROM and DVD-RW drives.
1. Do one of the following:
o For tower models, open and remove the bezel (" Remove the tower bezel " on page 21 ).
o For rack models, if installed, remove the security bezel (on page 21 ).
2. Power down the server (on page 20 ).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. For tower models, do the following: