HP Storage Mirroring Software - Manual (Page 86)

Recovery Page 85 of 214
l
Selected Data—This displays the amount of data, in gigabytes, currently on
the source volume.
l
Source Size—This displays the size, in gigabytes, of the volume on the
source.
l
Provisioned Volume—Specify the size, in gigabytes, of the volume to be
created on the new virtual.
l
Virtual Disk Type—For each volume you are protecting, specify the type of
disk, Dynamic or Fixed, that will be created on the virtual machine.
9. Click Next to continue.
10. Choose a datastore on the recovery server to store the protected data and system
state information that will be incoming from the repository server. You can only
select a datastore that has enough free space available. The amount of necessary
disk space is noted at the bottom of the page.
Note: If the size of the datastore is identical to the size of the disk on original
source and there is less than 20 MB of free space on that original source,
you may run out of disk space on the datastore due to differences in how
the virtual disk block size is formatted. In this case, make sure that your