HP ProLiant DL380 G5-Storage-Server - Manual (Page 97)

3. Click the iSCSI Targets node. On the details view (right pane), right-click and select Create
iSCSI Target.
4. Click Next on the Welcome page of the wizard.
5. On the iSCSI Target Identification page, type a name and description for the iSCSI Target
and then click Next.
6. On the iSCSI Initiators Identifiers page, type the iSCSI Qualified Name (IQN) of the iSCSI
initiator requesting access to the iSCSI Target in the IQN identifier field. The IQN is found on the
General tab of the Microsoft iSCSI Initiator interface.
Figure 24 iSCSI Initiators Identifiers page
7. To enter additional identifiers, or if you are using an identifier other than an IQN (DNS domain
name, IP address, or MAC address):
a. Click Advanced.
b. On the Advanced Identifiers page, click Add.
c. Select the identifier type from the Identifier Type list and type the identifier in the Value field.
d. Repeat steps b and c for each identifier you want to add.
e. Click OK.
f. Click OK again to close the Advanced Identifiers page.
HP ProLiant Storage Server 97