HP ProLiant DL380 G5-Storage-Server - Manual (Page 26)

• For the Telnet service to be started manually on every reboot, in the Startup Type drop-down
box, click Manual, and then click OK.
On the storage server, access the command line interface, either by Remote Desktop or a direct
connection, and then enter the following command:
net start tlntsvr
Sessions information
The sessions screen provides the ability to view or terminate active sessions.
Using the Integrated Lights-Out 2 method
Integrated Lights-Out 2 (iLO 2) is HP's fourth generation of Lights-Out management technology that
allows you to perform virtually any system administrator or maintenance task remotely as if you were
using its keyboard; mouse; monitor; power button; and floppy, CD or USB key, whether or not the
server is operating. It is available in two forms, iLO 2 Standard and iLO 2 Advanced. iLO 2 Standard
provides basic system board management functions, diagnostics and essential Lights-Out functionality on
supported ProLiant servers. iLO 2 Advanced provides advanced remote administration functionality as a
licensed option, which is included with the ProLiant Storage Server.
The Integrated Lights-Out port on the storage server can be configured through the Rapid Startup Wizard
or through the iLO 2 ROM-Based Setup Utility (RBSU). SNMP is enabled and the Insight Management
Agents are preinstalled.
The HP iLO 2 management processor provides multiple ways to configure, update, operate, and manage
servers remotely. The HP ProLiant Storage Server comes preconfigured with iLO 2 default factory settings,
including a default user account and password. These settings can be found on the iLO 2 Default
Network Settings tag found on the front of the server. If iLO 2 is connected to a network running DNS
and DHCP, you can use it immediately without changing any settings.
For more information on using HP iLO 2, see the HP Integrated Lights-Out 2 User Guide.
To quickly set up iLO 2 using the default settings for iLO 2 Standard and iLO 2 Advanced features,
follow the steps below
1. Ensure that a network cable is connected to the iLO 2 port located on the back of the storage server.
NOTE:
This connection method is easiest when the connection is to a DHCP and DNS supported
network.
2. If you are not using dynamic DHCP (IP addressing), you will need to input a static IP address by
using the direct attach method and the iLO 2 RBSU.
3. Using the methods described in the HP Integrated Lights–Out 2 User Guide, connect to the iLO 2 port.
NOTE:
To find the default iLO 2 log on settings, see the iLO 2 Default Network Settings card
attached to your server. The default DNS, administrator name, and password needed to
log on will be on this card.
4. If desired, you can change the default user name and password on the administrator account to
your predefined selections.
5. Set up your user accounts, if using the local accounts feature.
6. Activate iLO 2 advanced features by entering a license key from the included ProLiant Essentials
Integrated Lights-Out 2 Advanced Pack.
26 Installing and configuring the server