Allied Telesis AR44xS - Manual (Page 5)

Features in 281-02 5
Version 281-02
C613-10482-00 REV B
CR00012476 IGMP 2 If IGMP snooping was enabled but IGMP was not enabled, the snooper behaved
as if IGMP snooping fast leave had been enabled even when it had not been. This
meant that as soon as the snooper received a Leave message, the port left the
group.
This issue has been resolved. Note that fast leave is disabled by default.
Y - Y - - Y - - - -
CR00012657 STP 2 When STP was operating with a large number of VLANs in the same STP region,
the switch sometimes rebooted while processing topology change notifications
(TCNs).
This issue has been resolved.
- - - - - Y - - - -
CR00012741 Core, File,
Stack
2 The command create config=filename set did not copy the configuration file
to all switches in the stack, but only saved the file onto the current switch.
This issue has been resolved.
- - - - - Y - - - -
CR00013081 Switch, STP 2 When STP was enabled on ports in a trunk group, the non-master ports did not
have the same state as the master port in the switch’s hardware STG table. This
could, on rare occasions, create a broadcast storm.
This issue has been resolved. All ports in a trunk group follow the master port in
the hardware STG table.
- - - - - Y - - - -
CR00013128 ATM 2 When connected to some types of DSLAMs, the router could reboot due to a
reception error on the SHDSL EOC channel.
This issue has been resolved.
Y - - - - - - - - -
CR Module Level Description AR4
0
0
AR7
x
5
AR7
50S / AR770S
Ra
pi
er
i
AT
-8
8
0
0
AT
-8
6
0
0
A
T-
8
7
00XL
A
T-
8
9
48 / x900-
48
AT
-9
9
0
0
AT
-9
8
0
0