Allied Telesis AR44xS - Manual (Page 3)

Features in 281-02 3
Version 281-02
C613-10482-00 REV B
Features in 281-02
Software Maintenance Version 281-02 includes the resolved issues and enhancements in the following tables. In the tables, for each product series:
■ “Y” in a white column indicates that the resolution is available in Version 281-02 for that product series.
■ “-” in a white column indicates that the issue did not apply to that product series.
■ a grey-shaded column indicates that Version 281-02 was not released on that product series.
Level 1
CR Module Level Description AR400 AR7x5 AR750S / AR770
S
Rapi
er
i
A
T-
8800
A
T-
8600
A
T-
8700XL
A
T-
8948 / x90
0-
48
A
T-
9900
A
T-
9800
CR00006040 PIM 6 1 For PIM on IPv6, if the interface that was being used as the BSR candidate address
went down, the network occasionally did not re-elect a BSR and the RPs in a
timely manner. This could cause the router or switch to reboot.
This issue has been resolved.
Y - Y - - - - - - -
CR00007273 Switch 1 If a user created a configuration file that contained port trunk settings before
VLAN port settings, then a loop occurred when the switch rebooted with this
configuration.
This issue has been resolved.
- - - - - Y - - - -
CR00013457 VLAN 1 When ports were added to a currently-disabled RSTP domain, the ports could
start to discard packets (because their STP state was set to Discarding).
This issue has been resolved. When ports are added to a disabled RSTP domain,
they remain in a Forwarding state.
- - - - - Y - - - -
CR00013492 OSPF 1 When route filters (made with the command add ip route filter) were used to
filter OSPF routes, it was possible for OSPF to constantly remove and re-create an
AS-External LSA. This could prevent OSPF sessions from establishing.
This issue has been resolved.
Y - Y - - Y - - - -