Allied Telesis AR44xS - Manual (Page 20)

Features in 281-01 20
Version 281-02
C613-10482-00 REV B
CR00012868 ENCO 2 Entering the command create enco key=number ip=? caused the router or
switch to reboot.
This issue has been resolved.
Y Y Y Y Y Y Y Y Y Y
CR00012900 IPv6, Switch 2 When an IPv6 accelerator card was installed, IPv6 multicast traffic was flooded to
all ports in a downstream VLAN, whether or not they had joined the multicast
group.
This issue has been resolved.
- - - - - - - Y Y -
CR00012911 Switch, VLAN,
User
2 Under very rare circumstances, memory corruption could occur when packets
were transmitted by the CPU out a switch port.
This issue has been resolved.
Y - Y - - - - - - -
CR00012951 IPv6 2 RIPng (for IPv6) sometimes sent sub-optimal routes to its neighbours. When
RIPng was configured in a network with loop topology, this could cause unstable
routing table entries on the neighbours (the metric kept being updated, as a
result of updates from neighbours).
This issue has been resolved. RIPng no longer sends sub-optimal routes.
Y Y Y Y Y - - Y Y Y
CR00012952 Bridge 2 If a tagged packet was bridged out of a VLAN interface, the interface always
added a VLAN tag into the packet, even though the packet was already tagged.
This issue has been resolved.
Y Y Y - - - - - - -
CR00012991 ATM 2 The maximum allowed value of the vpi parameter in the commands add and set
atm channel has been increased from 8 to 15. Y - - - - - - - - -
CR Module Level Description AR4
0
0
AR7
x
5
AR7
50S / AR770S
Ra
pi
er
i
AT
-8
8
0
0
AT
-8
6
0
0
A
T-
8
7
00XL
A
T-
8
9
48 / x900-
48
AT
-9
9
0
0
AT
-9
8
0
0