AGFA 2100 - Manual (Page 28)

You should observe the following when you power on the printer:
— All control panel indicators light for a moment.
— The Ready indicator flashes and the display reads
02 WARMING UP (assuming that the printer has cooled below
operating temperature before it is powered on).
— The Online and Ready indicators remain on and the display reads
00 READY DEC.
NOTE: The display reads 00 READY DEC only if you are using
Digital’s ANSI-Compliant Printing Protocol level 3 (PPL3), which
is the factory default setting. If you are using an optional protocol
such as PostScript or CaPSL, the display shows the protocol being
used. For instance, if you are using PostScript protocol the display
reads 00 READY
PS. Since several protocols can be used with
the DEClaser 2100 printer, the remainder of this manual shows the
ready message as 00 READY.
If the printer does not power on correctly, refer to Chapter 6 for
troubleshooting information.
2–2 DEClaser 2100 Printer Operator’s Guide