AGFA 2100 - Manual (Page 128)

Table 6–3 (Cont.): Software Error Messages
Message Meaning Corrective Action
22 LINE ERROR The receiving buffer is
overflowing with data. Enable a handshaking protocol to
regulate data flow (see Section 4.5.6.4,
Section 4.5.6.5, and Section 4.5.6.6).
Ensure that the host, the printer, and
any other devices that are connected
(such as print servers) all have the
same type of handshaking protocol
enabled.
23 MEMORY FULL Memory cannot accept
additional downline load-
ing of fonts into memory. Clear fonts from memory after each
job.
Reallocate less bitmap page memory
space (Section 4.5.5.3).
Add additional RAM.
24 FULLPAINT REJ Full paint mode is not
allowed due to lack of
memory space. Clear fonts from memory after each
job.
Add additional RAM.
26 MEMORY FULL RAM memory space is
full. Clear fonts from memory after each
job.
Add additional RAM.
40 LINE ERROR An error has occurred
in the communication
circuit. Check the interface parameters (Sec-
tion 4.5.6).
Check the integrity of lines; be sure
cables are properly shielded and that
all ground screws are in place.
41 PRINT CHECK A misprint has occurred. Perform the error skip procedure
(Section 6.1).
42 ERROR There is an expansion
interface error. Power off the printer and verify that
any memory expansion boards are
correctly installed.
If the problem
continues, call Customer Services
(Chapter 8).
43 ERROR There is an expansion
interface error. Power off the printer and verify that
any memory expansion boards are
correctly installed.
If the problem
continues, call Customer Services
(Chapter 8).
Troubleshooting 6–5