HP Scripting Toolkit for Windows 9.60 - Manual (Page 45)

Comment or clarification Error message Error code
The command does not belong in the Logical Drive
section of the script file. is not a Logical Drive command. 2873
The command does not belong in the HBA section of
the script file. is not an HBA command. 2874
— More than one command cannot
exist in the same section. 2875
The script specifies more drives than are available of the
specified drive type. Invalid physical drive count. 2876
No drives were found that could be used as spares for the
specified array. No spares available. 2877
RAID 0 does not support spares. Spare request for RAID 0 is invalid. 2878
A controller reset with data loss was specified while in
Reconfigure mode. Reset and reconfigure combined error. 2879
— Invalid drive type specified. 2880
— Invalid value for MNPDelay. Valid range
is 0 (disabled) to 60 minutes. 2882
— Invalid controller configuration value.
Expecting Yes or No. 2883
— Invalid value for QueueDepth. Valid range
is from 2 to 32, or Auto. 2884
Using HPLPCFG
You must edit the text file to insert the WWID of the boot volume and the LUN number that the
WWID boots from. The HPLPCFG utility discovers the WWID of the HBA in the server blade and
writes the information in the text file. The text file presents the options in human readable format.
The HPLPCFG utility updates the hardware with the boot volume WWID and boot LUN read from
the text file.
HPLPCFG command-line syntax
hplpcfg —s filename hplpcfg —l filename hplpcfg —v
[HBA0] WWID=11223344 HostAdapterBiosEnable=1 SelectBootEnable=1
BootDeviceWWID=22334455 BootDeviceLUN[0]=1111
HPLPCFG command-line arguments
Description Command-line argument
This argument saves the HBA configuration to the filename. hplpcfg —s filename
This argument loads the HBA configuration to the filename. hplpcfg —l filename
This argument displays the tool version information. hplpcfg —v
Where filename has the following format:
Section for each HBA [HBA0]
Read-only variable WWID=11223344
Your input or current value when read from HBA HostAdapterBiosEnable=1
Your input or current value when read from HBA SelectBootEnable=1
Using HPLPCFG 45