HP Integrity rx4640 Server - Manual (Page 23)

Figure 2-4 Windows Firmware Package Installation
5. In the Firmware Update Scope section, select the type of upgrade:
•
Partition — for the current partition
• Complex — for the whole complex
• Partition+ — for the current partition plus unassigned cells
NOTE: HP does not support the use of Partition or Partition+ for mid-range systems.
6. Click Continue.
The Package installability check window appears, displaying status information. No action
is necessary. This window closes and another Package installability check window appears
as shown in
Figure 2-5 . This window displays the firmware versions on the system as
compared to those in the package and any errors that prevent the upgrade, which you must
resolve before continuing.
If you select complex and firmware that is the same as on the system, then you are prompted
to reinstall. If you select to reinstall, the Package installability check dialog box displays a
message about removing power, followed by a power cycle confirmation box. If instructed
to remove power to the system, see
Removing Power .
Updating Firmware on a Windows System 23